HydroHeat Fit From Below
HydroHeat Fit From Below systems utilises heat emission plates laid between the joists to the underside of your structural floor. These are pre-grooved to accommodate the underfloor heating pipework and specially designed to enable a straightforward install. We recommend packing the void with a soft insulation to prevent downwards heat loss and optimize the total heat output.

Features & Benefits
-
Insulation (WxLxD) – 350mm x 1200mm x 30mm
-
Aluminium Heat Plate – (WxL)– 390mm x 1000mm
-
Due to the lack of screed, HydroHeat Plates are significantly lighter than wet construction systems.
-
No need to use screed which enables lower profile of floor heating
-
HydroHeat Plates characteristics and structure evenly distribute heat over the entire surface while acting as a pipe bracket

Project Suitability
-
New builds and extensions
-
Good for large regular shaped rooms
-
Over solid concrete or block and beam subfloors
-
Where height build up is not an issue



